MX-6 V6-2496cc 2.5L DOHC (1996)
11. Tap the camshaft oil seal in evenly with the SST and a hammer.
12. Tap the new blind cap in by using a plastic hammer
CAMSHAFT PULLEY ASSEMBLY NOTE
The right and left pulleys are different and must be installed on the same head that they were removed from.
1. Install the RH camshaft pulley so that the "R" mark can be seen and the groove aligns with the camshaft knock pin.
2. Install the LH camshaft pulley so that the "L" mark can be seen and the groove aligns with the camshaft knock pin.
3. Apply clean engine oil to the camshaft pulley bolt threads.
4. Hold the camshaft by using a wrench on the cast hexagon as shown, and tighten the camshaft pulley lock bolt.
CYLINDER HEAD COVER ASSEMBLY NOTE
1. Apply silicone sealant to the shaded areas as shown.
Thickness: 1.5 - 2.5 mm (0.060 - 0.098 inch)
