MX-6 V6-2496cc 2.5L DOHC (1996)
8.
Repeat steps 6 and 7 (five to six times).
9.
Allow the throttle body to Sit for 5 minutes.
CAUTION:
DO NOT immerse the throttle body or any electrical components in the solution.
10.
Use a shop towel to wipe carbon deposits from the throttle body bore and throttle valve.
NOTE:
Remove all carbon deposits however, give special attention to the throttle valve to bore contact area.
11.
Repeat steps 6 - 10 if necessary.
12.
Blow the residue from the throttle body with compressed air.
13.
Remove all masking tape.
14.
Install a new gasket
15.
Install the throttle body. Refer to section F of the workshop manual.
16.
Start engine and run to normal operating temperature.
17.
Inspect idle speed, adjust if necessary Refer to section F of the workshop manual.
18.
Inspect timing, adjust if necessary. Refer to section F of the workshop manual.
19.
Verify repair effectiveness.
Disclaimer
