MX-6 V6-2496cc 2.5L DOHC (1996)
6. Adjust the throttle position sensor so that the PCM terminal 3B voltage is as specified, by using a voltmeter.
Specifications:
Closed throttle position: 0.1-1.1 V
Wide open throttle: 2.8-4.5 V
(Verify that the voltage increase is directly pro-portioned to the throttle valve opening angle.)
7. Tighten the attaching screws.
Tightening torque: 1.6-2.3 Nm (14-20 in.lbs.)
8. If not adjusted, inspect the throttle position sensor harness.
9. If harness is OK, replace the throttle position sensor.
Using SST (NGS)
1. Connect the SSTs to the data link connector-2.
2. Verify that the throttle valve is at the closed throttle position.
3. Loosen the attaching screws.
4. Turn the ignition switch to ON.
5. Select the PID/DATA MONITOR AND RECORD function of the NGS.
6. Select "TP V", on the NGS display. NGS measures and shows the voltage.
Specifications:
Closed throttle position: 0.1-1.1 V
Wide open throttle: 2.8-4.5 V
(Verify that the voltage increase is directly proportioned to the throttle valve opening angle.)
7. Tighten the attaching screws.
Tightening torque: 1.6-2.3 Nm (14-20 in.lbs.)
8. If not adjusted, replace the throttle position sensor.