MX-6 V6-2496cc 2.5L DOHC (1996)
NOTE:
Visually confirm alignment with the existing fender or quarter panel pin stripes for optimal appearance.
8.
Use a plastic squeegee to affix the pin stripe to the vehicle.
^
Start at the center working from top to bottom and work out all water and air bubbles.
^
Squeegee to the left, toward the rear of the door.
^
Repeat the process from the center to the right, front of the door.
9.
Carefully remove the pre-mask tape.
^
Grasp one end (front or rear).
^
Use a slow steady pulling motion.
^
Pull the pre-mask tape at approximately 180 degrees from the vehicle's surface.
CAUTION:
Confirm that the pin stripe is not lifting during pre-mask tape removal. Re-squeegee the pin stripe to assure that any loose edges adhere to the body.
10.
Remove any blisters or air bubbles.
^
Use a sharp needle to pierce the bubble.
^
Use your thumb to press the pin stripe firmly against the body panel and work the air or water toward the hole.
11.
Remove adhesive residue under the pre-mask area using isopropyl alcohol and a soft clean cloth.
Front Fender
1.
Follow steps 1 through 5 for door panel pin stripe.
2.
Position the alignment tab horizontally to the applied door pin stripe.
3.
Align the vertical edge of the notches near the tab to the edge of the fender panel.
4.
Align the forward part of the mask edge with the headlamp sheet metal edge.
NOTE:
Visually confirm alignment with the existing fender or quarter panel pin stripes for optimal appearance.
5.
Use a squeegee to apply the pin stripe and remove any air bubbles or water, working forward to the headlamp area.
CAUTION:
