MX-6 V6-2496cc 2.5L DOHC (1996)
Carrier Bearings: Adjustments
NOTE: Use the Special Service Tools (SSTs) shown below to measure and adjust the differential side bearing preload.
PRELOAD
1. Remove the bearing race and adjustment shims from the transaxle case.
2. Install the bearing race into the converter housing by using a pipe and a hammer.
3. Set the differential assembly into the converter housing.
4. Turn the selector to eliminate the gap indicated by the arrow.
5. Install the bearing race removed in step (1) into the SST and set them onto the differential assembly.