MX-6 V6-2496cc 2.5L DOHC (1996)
Connect The (+) Terminal Of A Dwell Meter To Terminal 2H At The Powertrain Control Module And The (-) Terminal To Ground
1. Connect the (+) terminal of a dwell meter to terminal 2H at the powertrain control module and the (-) terminal to a ground.
Set the dwell meter selector to the 4 cylinder position.
2. Engage the parking brake and use wheel chocks at the front and rear of the wheels.
3. Start the engine.
4. Depress the brake pedal firmly.
5. Shift the selector lever to D range.
NOTE: The dwell meter indicates the OFF duty ratio.
6. Check the duty ratio by depressing and releasing the accelerator pedal.
NOTE: The relationship between the dwell angle (0) and duty ratio (%) is as in image.
Duty Ratio Graph
7. Depress the accelerator pedal slowly and verify that the duty ratio charges as shown in the graph.
8. If not as specified, check the powertrain control module and pressure control solenoid.
Torque Converter Clutch Solenoid
Dwell Meter Connected To Terminal 2D Of The Powertrain Control Module And The (-) Terminal To Ground