MX-6 LS V6-2.5L DOHC (1997)
ABS Control Module: Testing and Inspection
Solenoid Valve Harness at Control Module Check
1. Turn the ignition switch OFF.
2. Measure the resistance between a ground and the following terminals at the ABS control module connector (12 pin).
^
Terminal:
1A, Right rear
1B, Left front
1C, Right front
1D, Left rear
^
Resistance: 2-5 ohms.
3. If not as specified, check the wiring harness between the ABS hydraulic unit connector (8 pin) and the ABS control module for open or short
circuit.
