MX-6 LS V6-2.5L DOHC (1997)
2. Install the control valve body assembly and tighten to 11 - 14 Nm (95 - 130 inch lbs.).
3. Match the harness colors and connect the solenoid connectors and transaxle fluid temperature sensor connector.
4. Install a new gasket and the control valve body cover. Tighten to 8 - 10 Nm (74 - 95 inch lbs.).
CAUTION: If reusing the hose clamp, position it in the original location on the hose and squeeze the clamp lightly with large pliers to ensure a
tight fit.
5. Align the marks, and slide the oil cooler hose onto the oil cooler pipe until it is fully seated as shown.
6. Install the hose clamp onto the hose at the center of the mark and at the angle shown.
7. Verify that the hose clamp does not interfere with any other parts.
8. Slide the radiator hose onto the radiator pipe until it is fully seated.
9. Install the hose clamp on the hose.
10. Squeeze it lightly with large pliers to ensure a good fit.
11. Install the splash shield.
12. Fill the radiator and reservoir with the specified amount and type of engine coolant.
13. Connect the negative battery cable.
14. Fill the transaxle with the specified ATF.
15. Check for leakage of ATF from the oil pan or the oil hose connecting points.
16. Carry out the mechanical system test.
17. Carry out the road test.
