MX-6 LS V6-2.5L DOHC (1997)
1. Turn the clip with the opening facing upward.
2. Apply grease to the ends of the drive shafts.
CAUTION: The oil seals are damaged easily if this procedure is not done correctly.
3. Push the drive shaft into the transaxle (left side) or joint shaft (right side).
4. After installation, pull the front hub outward to confirm that the drive shaft is securely held by the clip.
5. Install the lower arm ball joint to the knuckle and tighten the through bolt to 35 - 56 Nm (26 - 41 ft. lbs.).
Locknut
6. Install a new locknut and stake it as shown. Tighten to 236 - 318 Nm (173 - 235 ft. lbs.).
