MX-6 LS V6-2.5L DOHC (1997)
3. Set the bearing races into the Special Service Tools (SSTs) (selector) as shown in the illustration.
4. Turn the selector to eliminate the gap indicated by the arrow.
5. Set the differential assembly into the clutch housing, and set the bearing race and the SST (selector) on the differential. Set the assembled selectors
for the primary and secondary shaft in the clutch housing. Mount the shaft gear assemblies as shown in the illustration.
6. Set the SST (collars) in the positions shown in the illustration.
7. Install the transaxle case and tighten the SST (bolts) to 38 - 51 Nm (28 - 38 ft. lbs.).
8. To seat the bearings, mount the SST (bars) on parts (A) and (B) of the selectors, and turn the selectors so the gaps are widened. Then turn the SST
in the reverse direction until the gaps are eliminated.
