MX-6 LS V6-2.5L DOHC (1997)
Clutch Hub
Install the synchronizer keys and springs in the clutch hub.
Bearing (Secondary Shaft End)
Install the new secondary shaft end bearing by using the Special Service Tool (SST).
1st Gear, 1st Synchronizer Ring And 1st/2nd Clutch Hub Assembly
NOTE: The 2nd synchronizer ring has teeth missing at three places around its outer edge to help distinguish it from the other synchronizer rings.
1. Assemble the 1st gear, 1st synchronizer ring, and 1st/2nd clutch hub assembly.
2. Align the synchronizer ring grooves and synchronizer keys.
3. Press the 1st/2nd clutch hub assembly on by using the SST.
