Protege L4-1.5L DOHC (1995)
Steering lock (ATX)
Verify that the cable connector does not move when the key is in the LOCK position and that it moves freely with the key in other positions.
Steering lock
1. Install the steering lock assembly on the jacket.
2. Verify that the lock operates correctly.
3. Install new steering lock mounting bolts.
4. Tighten the bolts until the heads break off.
Steering shaft assembly and universal joint
Caution:
^
Do not apply the shock in the axial direction of the shaft.
1. Tighten bolts A, B and C.
2. Tighten bolt D with the steering shaft at its upper most tilt position.
3. The paint must be visible after tightening the bolt D.
4. After installation, lightly tap the lower bracket at the E point shown by using a hammer to verify correct installation.
Steering wheel
Set the wheels in the straight-ahead position, and install the steering wheel.