Protege L4-1.5L DOHC (1995)
Differential: Testing and Inspection
Backlash of side gear and pinion gear
Measure the backlash by the following procedure.
1. Install the left drive shaft and the joint shaft in the differential assembly.
2. Support the drive shaft and joint shaft on V-blocks.
3. Measure the backlash of both pinion gears.
Backlash: 0 - 0.1 mm (0 - 0.004 in)
4. If the backlash exceeds specification, adjust by selecting and installing thrust washers between the case and the side gears.
CAUTION: Use thrust washers with the same thickness on each side.
Ring gear and gear case assembly
NOTE: If the gear case is replaced, adjust the bearing preload.
Inspect the ring gear for wear and cracks.
Bearing
