mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Rear Speakers - Intermittent or No Sound|Page 4434 > < Diagram Information and Instructions|Page 4424
Page 1
background image

Speaker Connector Pigtail Assembly: All Technical Service Bulletins
Rear Speakers - Intermittent or No Sound

Bulletin No.: 007/93
Issued: 11/26/93
Revised: 

Category

T

Applicable Model/s
1990 - 94 Protege

Subject:
NO SOUND/INTERMITTENT SOUND FROM REAR SPEAKERS

APPLICABLE MODEL/VINS
1990 - Vehicles with a VIN of JM1BG224*L0100001 through JM1BG224*L0199999
1991 - Vehicles with a VIN of JM1BG224*M0200001 through JM1BG224*M0299999
1992 - Vehicles with a VIN of JM1BG224*N0400001 through JM1BG224*N0499999
1993 - Vehicles with a VIN of JM1BG224*P0500001 through JM1BG224*P0599999
1994 - Vehicles with a VIN of JM1BG224*R0700001 through JM1BG224*R0722466

DESCRIPTION
Some vehicles may experience a no sound or intermittent sound operation from the rear speakers. Prior to the production change date, the rear speaker
terminals are exposed in the luggage compartment area. The terminals may come into contact with the cargo (especially large, bulky baggages) and may
break causing the inoperable condition(s).

After August 31, 1992, the rear speakers have been turned one (1) speaker screw position (or +/- 1205) away from the luggage compartment area. This
change "hides" the rear speaker terminals. They are no longer exposed in the luggage compartment area.

REPAIR PROCEDURE
If the above condition occurs, inspect the speaker cord connector and speaker terminals. If the speaker cord connector is broken, replace with a short
cord assembly and reposition both speakers as outlined in the procedures below. If the speaker terminal(s) is broken, replace the affected speaker(s).

If the speaker terminal in either one of the speakers is broken, replace the affected speaker as follows:

1.

Open the rear trunk and remove the speaker cord connector.

2.

From the passenger area, remove the fasteners and the rear package trim.

3.

Remove the three (3) screws on each speaker. Figure 1.

4.

Remove damaged speaker(s).

Rear Speakers - Intermittent or No Sound|Page 4434 > < Diagram Information and Instructions|Page 4424