Protege L4-1839cc 1.8L DOHC (1990)
-
If runout is within specification, proceed to STEP 3. If runout is not within specifications, measure the disc plate thickness.
^
If disc plate is not within minimum thickness specification, replace it and return to STEP 2.
^
If rotor can be machined within specification, machine the rotor using the ACCUTURN On-Car brake lathe or equivalent.
Note
^
The on-car brake lathe MUST mount to the steering knuckle, NOT to the hub.
3.
Remove the upper and lower guide plates from the knuckle and adjust the prongs so that the distance between the them is 10.8 mm.
4.
Clean the caliper and brake pad slide surfaces with a wire brush.
5.
Reinstall the adjusted guide plates and apply a small amount grease to the rubbing surfaces.
6.
Replace the main sleeve and rubber seals (supplied with main sleeve) with modified parts.
Note
Before installing new main sleeve, apply the grease that is supplied with the modified main sleeves to the outside of the sleeve and inside of the
new rubber seals.
7.
Mount the caliper assembly to the steering knuckle and tighten the sleeve bolts.
Tightening Torque:
49. - 58.8 Nm (5.0-6.0 kgfm, 36.3-3.5 ft. lbs.)
8.
Repeat procedure on other side of vehicle if necessary.
9.
Verify repair.
PART(S) INFORMATION
WARRANTY INFORMATION
Note
This information applies to verified customer complaints on vehicles covered under normal warranty. Refer to the SRT microfiche for warranty term
information.
Warranty Type
A
Symptom Code
82
Damage Code
9C
Part Number Main Cause
BRY5 33 26Z
