Protege L4-1839cc 1.8L DOHC (1990)
Timing Belt Tensioner: All Technical Service Bulletins
Timing Belt - Squeal or Whine Noise
Bulletin No.: 003/94
Issued: 2/11/94
Revised: 2/25/94
Category: B
Applicable Model/s
SEE BELOW
Subject
NOISE AROUND TIMING BELT
NOTE:
The revised portion of this bulletin is indicated by an asterisk (*). Replace the original with this revised copy.
APPLICABLE MODELS/VINS
DESCRIPTION
A squeal or whine may be heard around the timing belt tensioner after cold starting. This is caused by a decrease in the clearance of the tensioner bearing
when tightening the tensioner bolt. To prevent this condition, the bottom thickness of the tensioner has been increased from 5 mm to 8 mm to increase
rigidity. The radial clearance of the tensioner bearing has also been increased.
REPAIR PROCEDURES
1.
Verify the complaint.
2.
If the squealing is heard, replace the tensioner pulley with a new part.
PARTS INFORMATION