Protege L4-1839cc 1.8L DOHC (1990)
Throttle Valve Cable/Linkage: All Technical Service Bulletins
A/T - Throttle Cable Won't Move After Rebuild Install
Bulletin No.: 001/93
Issued: 2/12/93
Revised
Category
K
Applicable Model/s
See Below
Subject:
THROTTLE CABLE WILL NOT MOVE AFFER INSTALLING REBUILT A/T
NOTE:
This bulletin supercedes Service Bulletin # 020/92, Cat. K, issued 12/15/92.
APPLICABLE MODELS
1990-92 323
1990-92 Protege
1992 MX-3
DESCRIPTION
On rebuilt A/T units, a pin is used for holding the throttle cam in place to make installation of the control valve easier. If a rebuilt A/T is installed
without removing the pin, the throttle lever will remain in a fixed position and the throttle cable will not move.
REPAIR PROCEDURE
1.
When installing a rebuilt A/T, be sure to remove the throttle cam pin (Pin A).
2.
Also, remove the throttle cam bolt (Bolt B) from the original A/T (unit that is being replaced) and reinstall into the throttle cam of the replacement
rebuilt A/T. If needed, this bolt may be ordered separately, under part number FU61 19 423. Bolt B is an allen screw, socket head bolt. See
illustration.
When installing the bolt, apply sealant to prevent oil leakage.
NOTE:
Inspect and adjust the throttle cable after installing the rebuilt A/T as outlined in Section K of the applicable Workshop Manual.
PARTS INFORMATION
