Protege L4-1839cc 1.8L DOHC (1990)
Drive Shaft and Axle Component (6)
Separate the right-side drive shaft from the joint shaft by hammering on a brass or copper bar inserted between them.
Joint Shaft (7)
Pull the joint shaft straight out
Installation Note
Clip (8)
1. Install a new clip so that the opening is facing upwards.
2. Measure the outer diameter of the clip after installing, and replace the clip if it exceeds the specification. Outer diameter of 30 mm (1.181
inch) maximum.
Joint Shaft (7)
Tighten the bolts in the order shown to 43 - 61 Nm (32 - 45 ft. lbs.).
