Protege L4-1839cc 1.8L SOHC (1992)
2. Fill the wheel side boot with the appropriate grease amount supplied in the boot kit.
Tripod Joint, Outer Ring, and Snap Ring (5, 3, 4)
1. Fill the outer ring and differential-side boot with the appropriate grease amount supplied in the boot kit.
2. Align the marks and install the tripod joint and free rings.
3. Install a new snap ring by using snap-ring pliers.
4. While supporting the free rings, install the outer ring.
Boot Band (1)
1. Verify that the boots are not dented or twisted.
2. Set the drive shaft to the standard length.
Standard Length:
Right Side
B6 SOHC, MTX and ATX - 919.3mm (36.19 inches). BP SOHC, MTX and ATX - 918.7mm (36.17 inches). BP DOHC, MTX and ATX -
630.7mm (24.83 inches).
Left Side
B6 SOHC, MTX and ATX - 637.8mm (25.11 inches). BP SOHC, MTX and ATX - 640.2mm (25.20 inches). BP DOHC, MTX - 621.2mm (25.2
inches), ATX - 637.2 (25.09 inches).
