Protege L4-2.0L DOHC (2003)
4. Connect the SST (49 H066 002) to the SST (49 D066 003).
5. Connect the red clip of the SST (49 H066 002) to the positive battery terminal and the black clip to the negative battery terminal.
6. Verity that the red light on the SST (49 H066 002) is illuminated.
7. Make sure all persons are standing at least 6 m {20 ft} from the vehicle.
8. Press the activation switch on the SST (49 H066 002) to deploy the pre-tensioner seat belt.
Deployment Procedure for Outside of Vehicle
1. Inspect the SST (Deployment tool). (See INSPECTION OF SST (DEPLOYMENT TOOL).)
2. Turn the ignition switch to LOCK position.
3. Disconnect the negative battery cable and wait for more than 1 minute.
4. Follow the appropriate procedure for deploying the driver-side air bag module, passenger-side air bag module, or side air bag module.
Driver-side air bag module
1. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION.)
2. Place the driver-side air bag module on the center of the wheel with the module facing up. See the illustration below.
-
To secure the air bag module to the wheel, wrap the wire harness through the wheel and the bolt installation hole at least 4 times.
WARNING: If the air bag module is not properly installed to the wheel, serious injury may occur when the module is deployed.
When installing the air bag module to the wheel, make sure the module is facing up.
