Protege L4-2.0L DOHC (2003)
2. Connect the SST (104 Pin Breakout Box) to the PCM as shown.
3. Tighten the connector attaching screw.
Tightening torque
7.9 - 10.7 N.m {80 - 110 kgf.cm, 69.5 - 95.4 in.lbf}
4. Inspect for an open or short circuit in the following wiring harnesses by probing the applicable sensor and SST (104 Pin Breakout Box) terminals
with ohmmeter leads.
-
If there is an open or short circuit, repair or replace wiring harnesses.
-
If there is no open or short circuit, replace the HO2S.
Open circuit
-
Control circuit (HO2S connector terminal C and ignition switch (IG1) circuit through common connector)
-
GND circuit (HO2S connector terminal D and PCM connector terminal 94 (Front), 93 (Rear))
Short circuit
-
Control circuit (HO2S connector terminal C and ignition switch (IG1) circuit through common connector to GND)
-
GND circuit (HO2S connector terminal D and PCM connector terminal 94 (Front), 93 (Rear) to GND)
5. Reconnect the HO2S connector.