Protege L4-2.0L DOHC (2003)
Alignment: Service and Repair
Front Wheel Alignment
Maximum Steering Angle Adjustment
1. Loosen the tie-rod end locknuts.
2. Remove the steering gear boot clamp.
3. Turn the left and right tie rods to equalize the length L.
Maximum left/right difference 3 mm (0.12 inch)
Note: Turn the tie rods equally.
4. Turn the tie rod to provide the correct maximum steering angle.
5. Tighten the tie-rod end locknuts.
Tightening torque 68.7 - 98.0 Nm (7.0 - 10.0 kgf-m, 50.7 - 72.3 ft. lbs.)
6. Verify that the boot is not twisted, and install the boot clamp.
7. Adjust the toe-in after adjusting the steering angle.
Camber and Caster Adjustment
1. Jack up the front of the vehicle and support it on safety stands.
2. Remove the mounting block nuts.