Protege L4-2.0L DOHC (2003)
1. Set the SSTs into the valve side.
2. Install the SST to the gear housing.
3. Press the oil seal and inner guide out.
Mounting Rubber Disassembly Note
1. Press the mounting rubber out from the gear housing using the SSTs and a press.
Tie-rod End Boot Disassembly Note
1. Secure the tie-rod end in a vise.
2. Place a chisel against the boot and hold it at the angle shown.
3. Remove the boot by tapping it with a hammer.
STEERING GEAR AND LINKAGE INSPECTION
Rack Inspection
1. Inspect the rack for cracking, damage, and tooth wear.
^
Replace it as necessary.
