Protege L4-2.0L DOHC (2003)
Wheel Hub Component Removal Note
1. Remove the wheel hub component using the SSTs.
2. If the bearing inner race remains on the front wheel hub component, grind a section of the bearing inner race until approximately 0.5 mm (0.020
inch) remains. Then remove it using a chisel.
Wheel Bearing Removal Note
1. Remove the wheel bearing using the SSTs.
Dust Cover Removal Note
Note:
^
The dust cover does not need to be removed unless it is being replaced.
1. Mark the dust cover and steering knuckle for proper installation.
