Protege L4-2.0L DOHC (2003)
^
Applying load to the interlock cable while pressing the lock piece in can affect the lock unit operation.
9. Press the interlock cable lock piece in until it is locked.
10. Screw the brake switch into the slider pin of the lock unit as far as possible.
11. From this position, turn the brake switch counterclockwise about 90 degrees, then tighten the lock nut.
Tightening torque 13.8 - 17.6 Nm (140 - 180 kgf.cm, 122 - 156 inch lbs.)
12. Remove the lock unit pin in the order shown in the figure.
Selector Cable Installation Note
Caution:
^
Do not apply load to the manual shaft after manual shaft is shifted to P position. Otherwise, the transaxle may be damaged.
1. Turn the manual shaft to the converter housing side fully, to set the P position.
