Protege L4-2.0L DOHC (2003)
9. Install the SST into the transaxle to hold the side gears after drive shaft is removed.
Drive Shaft Installation Note
(Left side)
1. Install a new clip onto the drive shaft with the opening facing upward. Ensure that the diameter of the clip does not exceed the specification on
installation.
Outer Diameter Specifications
2. After installation, measure the outer diameter.
^
If it exceeds the specification, repeat Steps 1 - 2 using a new clip.
Caution:
^
The sharp edges of the drive shaft can slice or puncture the oil seal. Be careful when installing the drive shaft to the transaxle.
^
The oil seals are damaged easily if this procedure is not done correctly.
3. Insert the drive shaft into the wheel hub.
4. Apply ATF to the oil seal lip.
5. Push the drive shaft into the transaxle.
6. After installation, pull the transaxle side outer ring forward to confirm that the drive shaft is securely held by the clip.
(Right side)
1. Install the joint shaft with the end-gap of a net clip facing upward.
2. Install the drive shaft into the wheel hub.
3. Push the drive shaft into the joint shaft.
4. After installation, pull the transaxle side outer ring forward to confirm that the drive shaft is securely held by the clip.
