Protege L4-2.0L DOHC (2003)
3. Remove the glass.
Reusing Rear Window Glass
NOTE: Before removing the rear window glass from the body, mark the position of the rear window glass by affixing tape to the windshield and body
panel.
1. Use an awl to saw through the sealant except where there are fasteners and spacers, from the inside of the vehicle.
2. Pass the SST (piano wire) through the hole.
WARNING: Using a SST (piano wire) with bare hands can cause injury. Always wear gloves when using a SST (piano wire).
3. Wind each end of the wire around a bar.
4. Working with another person, saw through the sealant around the edge of the glass, being careful not to damage the body.
NOTE: Use a long sawing action to spread the work over the whole length of the SST (piano wire) to prevent it from breaking.
5. Remove the rear window glass.
