Protege DX L4-1.6L DOHC (2000)
3. Apply engine oil to the camshaft and the cylinder head journals.
4. Install the camshaft caps to the positions from which they were removed.
5. Hand tighten the camshaft cap bolts marked 5, 7, 2, and 4.
6. Tighten the camshaft cap bolts a few turns in the order shown.
7. Verify that the camshaft settles horizontally when 2 bearing cap bolts at No.3 journal are tightened.
8. Apply clean engine oil to the camshaft oil seal.
9. Push the oil seal slightly in by hand.
10. Tap the oil seals in evenly using the SST and a hammer.
Camshaft Pulley Installation Note
1. Install the camshaft pulleys with the "I" mark (intake side) or "E" mark (exhaust side) straight up.
2. Hold the camshaft using a wrench on the cast hexagon as shown.
