Protege DX L4-1.6L DOHC (2000)
Air Bag Module: Service and Repair
Driver-Side Air Bag Module
Removal and Installation
WARNING:
- Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read AIR BAG SYSTEM
SERVICE WARNINGS before handling the air bag module. (See AIR BAG SYSTEM SERVICE WARNINGS.) See: Service Precautions
1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Turn the ignition switch to ON position.
6. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
If the air bag system warning light does not operate in the manner described, there are malfunctions in the system. Inspect the system using the
on-board diagnostic function.See: Testing and Inspection
Connector Installation
Note:
- Install the connector as shown in the figure.
Deployment Procedures For Inside of Vehicle
WARNING:
- A live (undeployed) air bag module may accidentally deploy when it is disposed of and cause serious injury. Do not dispose of a live (undeployed) air
bag module. If the SSTs (Deployment tool and Adapter harness) are not available, consult the nearest Mazda representative for assistance.
CAUTION:
- Deploying the air bag modules inside the vehicle may cause damage to the vehicle interior. When the vehicle is not to be scrapped, always deploy the
