Protege DX L4-1.6L DOHC (2000)
2. Separate the tie-rod end from the steering knuckle using the Special Service Tools (SSTs).
ENGINE MOUNT MEMBER REMOVAL NOTE
1. Set the SSTs as shown in the figure.
2. Remove the engine mount member.
BOLT (INTERMEDIATE SHAFT) REMOVAL NOTE
1. Mark the pinion shaft and gear housing for proper installation.
STEERING GEAR AND LINKAGE REMOVAL NOTE
1. Remove the steering gear and linkage by pulling it from the right side.
BOLT (INTERMEDIATE SHAFT) INSTALLATION NOTE
1. Align the marks and install the intermediate shaft and bolt.
