Protege DX L4-1.6L DOHC (2000)
Suspension Strut / Shock Absorber: Service and Repair
Front Suspension
FRONT SHOCK ABSORBER AND SPRING REMOVAL/INSTALLATION
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if
it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-sensor (axle side) and fix it to an appropriate place where
the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Inspect the front wheel alignment.
^
If not as specified, adjust the front wheel alignment.
PISTON ROD NUT REMOVAL NOTE
Warning Removing the piston rod nut is dangerous. The shock absorber and spring could fly off under tremendous pressure and cause
serious injury or death. Secure the shock absorber in the SSTs before removing the coil spring nut.
1. Protect the coil spring using a piece of cloth, then set the Special Service Tools (SSTs).
