Protege DX L4-1.6L DOHC (2000)
9. Press the interlock cable lock piece in until it is locked.
10. Screw the brake switch into the slider pin of the lock unit as far as possible.
11. From this position, turn the brake switch counterclockwise about 90 degrees, then tighten the lock nut.
Tightening torque
13.8 - 17.6 Nm (140 - 180 kgf.cm, 122 - 156 inch lbs.)
12. Remove the lock unit pin in the order shown in the figure.
Selector Cable Installation Note
Caution: Do not apply load to the manual shaft after manual shaft is shifted to P position. Otherwise, the transaxle may be damaged.
1. Turn the manual shaft to the converter housing side fully, to set the P position.
