Protege DX L4-1.6L DOHC (2000)
ABS SENSOR ROTOR (WITH ABS) DISASSEMBLY NOTE
Caution
-
Do not remove the sensor rotor unless it is necessary.
-
Do not reuse the sensor rotor if removed.
1. Tap the ABS sensor rotor off the drive shaft using a chisel.
ABS SENSOR ROTOR (WITH ABS) ASSEMBLY NOTE
1. Set a new ABS sensor rotor on the drive shaft and press it on using the Special Service Tools (SSTs).
DYNAMIC DAMPER (MTX) ASSEMBLY NOTE
1. Install the dynamic damper as shown in the figure.
Standard length
292 - 298 mm (11.5 - 11.7 inch)
2. Install the new boot band onto the dynamic damper.
