Protege DX L4-2.0L DOHC (2002)
Brake Master Cylinder: Service and Repair
Removal and Installation
MASTER CYLINDER REMOVAL/INSTALLATION
1 of 2
2 of 2
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Master Cylinder Installation Note
FS
1. Turn the nut of the SST clockwise to fully retract the SST gauge rod. Attach the SST to the power brake unit.
Tightening torque 9.9 - 15 Nm (1.0 - 1.6 kgf-m, 7.3 - 11 ft. lbs.)
2. Apply a 66.7 kPa (500 mm Hg, 19.7 in Hg) vacuum by using a vacuum pump.
3. Turn the adjusting nut of the SST counterclockwise until the gauge rod just contacts the push rod end of the power brake unit. Push lightly on the
