Protege DX L4-2.0L DOHC (2002)
^
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and set it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
REMOVAL/INSTALLATION NOTES
ABS Sensor Rotor (With ABS) Installation Note
1. Set the SST as shown in the figure.
Caution:
^
Position the SST so that marking B faces the bottom.
2. Press on the new sensor rotor using the SST and a press.