Protege DX L4-2.0L DOHC (2002)
Transmission Speed Sensor: Service and Repair
Input/Turbine Speed Sensor
INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Disconnect the input/turbine speed sensor connector.
4. Remove the input/turbine speed sensor.
5. Apply ATF to a new O-ring and install it on a new input/turbine speed sensor.
6. Install the input/turbine speed sensor.
Tightening torque 7.9 - 10.7 Nm (80 - 110 kgf.cm, 69.5 - 95.4 inch lbs.)
7. Connect the input/turbine speed sensor connector.
8. Install the air cleaner component.
9. Connect the negative battery cable.
