Protege LX L4-1.6L DOHC (2000)
Air Door Actuator / Motor: Service and Repair
1. Disconnect the airflow mode wire from the airflow mode main link.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Adjust the airflow mode wire.
Airflow Mode Main Link Installation Note
CAUTION: If any grease other than the specified grease is applied to the links, abnormal noise will occur or the links will not properly operate.
Therefore, do not apply any grease to the links.
1. Push and hold each airflow mode sub link in the direction shown by the arrow.
2. Set the airflow mode main link to the heater unit as shown in the figure.
3. Press the airflow mode main link lightly and rotate it in the direction shown by the arrow, then set the projections of each airflow mode sub link
into the grooves of the airflow mode main link.
4. Rotate airflow mode main link and verify that each mode is accessed properly.
