Protege LX L4-1.6L DOHC (2000)
Transmission Position Switch/Sensor: Testing and Inspection
Neutral Switch Inspection
NOTE: Perform the following test only when directed.
1. Disconnect the negative battery cable.
2. Remove the neutral switch.
3. Inspect for continuity between the neutral switch terminals A and B using an ohmmeter.
-
If not as specified, replace the neutral switch.
-
If the neutral switch is okay, but PID value or PCM terminal 64 voltage are out of specification, carry out the "Circuit Open/Short Inspection".
Circuit Open/Short Inspection
1. Remove the PCM.
Specification
2. Connect the SST (104 Pin Breakout Box) to the PCM as shown.
3. Tighten the connector attaching screw.
Tightening torque:
7.9 - 10.7 N.m {80 - 110 kgf.cm, 69.5 - 95.4 in.lbf}
4. Inspect for an open or short circuit in the following wiring harnesses by probing the applicable sensor and SST (104 Pin Breakout Box) terminals
with ohmmeter leads.
-
If there is an open or short circuit, repair or replace wiring harnesses.
-
If there is no open or short circuit, replace the neutral switch.