Protege LX L4-1.6L DOHC (2000)
Transmission Position Switch/Sensor: Testing and Inspection
Transaxle Range Switch Inspection
TRANSAXLE RANGE (TR) SWITCH INSPECTION
Note: Input signals of the TR switch can be inspected with a NGS tester.
Inspection of Operation
1. Verify that the starter operates only with the IG SW at the START position and the selector lever in P and N positions.
-
If not as specified, inspect for continuity at the TR switch.
2. Verify that the back-up lights illuminate when shifted to R position with the ignition switch at the ON position.
-
If not as specified, inspect for continuity at the TR switch.
Inspection of Continuity
1. Disconnect the negative battery cable.
2. Remove the fresh-air duct and air cleaner component
3. Disconnect the TR switch connector.
4. Inspect for continuity at the TR switch.
-
If not as specified, replace or adjust the TR switch.
5. Connect the TR switch connector.
6. Install the air cleaner component and fresh-air duct.
7. Connect the negative battery cable.