Protege LX L4-1.6L DOHC (2000)
8. Connect an ohmmeter between terminals A and H.
9. Adjust the switch to the point where there is continuity between the terminals.
10. Tighten the TR switch mounting bolts.
Tightening torque
7.9 - 10.7 Nm (80 - 110 kgf.cm, 69.5 - 95.4 inch lbs.)
11. Verify that the selector lever range position and TR switch are aligned.
12. Connect the TR switch connector.
13. Install the clip as shown in the figure.
14. Connect the selector cable.
15. Install the splash shield.
16. Install the air cleaner component and fresh-air duct.
17. Connect the negative battery cable.
