Protege LX L4-1.6L DOHC (2000)
Repairs and Inspections Required After a Collision: Service and Repair
Side Air Bag Module
When the side air bag module deploys due to a collision, the interior of the seat back (pad, frame, etc.) may become damaged. If the seat back is
reused and the side air bag module does not deploy properly, a serious accident may result. When the side air bag module deploys, always replace
both the side air bag module and the seat back (pad, frame, trim) with new parts. After service, confirm that the seat operates normally and that the
harness Is positioned properly.
SAS Control Module
For vehicles with a single point sensor, once an air bag module is deployed due to an accident or other causes, the SAS control module must be
replaced with a new one even if the used one does not have any external signs of damage. The used SAS control module may have been damaged
internally which may cause improper operation, resulting in major injuries or even death. The used single point SAS control module cannot be
bench-checked or self-checked.
Side Air Bag Sensor
Because a sensor is built into the side air bag sensor, when the side air bag module operates (deploys), there may be a problem, such as an Internal
malfunction, even if there Is not any external damage or deformation. If the side air bag sensor Is reused, the side air bag module may fall to operate
normally and cause a serious injury. Always replace the side air bag sensor with a new part. The side air bag sensor cannot be bench-checked or
self-checked.
Component Reusing
Even if an air bag module does not deploy In a collision and does not have any external signs of damage, it may have been damaged internally, which
may cause improper operation. Improper operation may cause serious injury. Always self-check the undamaged air bag module to determine whether
it can be reused.
