Protege LX L4-1.6L DOHC (2000)
18. Tighten the manual shaft nut using a torque wrench.
Tightening torque
32 - 46 Nm (3.2 - 4.7 kgf.m, 24 - 33 ft. lbs.)
19. Install the clip as shown in the figure.
20. Verify that the selector lever range position and TR switch are aligned, then connect the selector cable.
21. Inspect for continuity at the TR switch.
22. Connect the TR switch connector.
23. Install the splash shield.
24. Install the air cleaner component and fresh-air duct.
25. Connect the negative battery cable.
26. Inspect operation of the TR switch.
