Protege LX L4-1489cc 1.5L DOHC MFI (1998)
1. Turn the ignition switch to LOCK.
2. Disconnect the negative battery cable and wait for more than 1 minute to allow the backup power supply of the SAS unit to deplete its stored
power.
3. Remove the passenger's side front scuff plate.
4. Remove the passenger's side front side trim.
5. Remove the glove compartment.
6. Remove in the order indicated in the table.
7. Install in the reverse order of removal.
8. Turn the ignition switch to ON.
9. Verify that the air bag system warning light illuminates for approximately 6 seconds then goes off.
10. If the air bag system warning light remains on, off, or repeats flashing after servicing, there are malfunctions in the system. Carry out the
inspection again. See: Testing and Inspection/Symptom Related Diagnostic Procedures