mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Suspension - Rear Suspension Thumping Noise|Page 3348 > < Suspension - Rear Suspension Thumping Noise|Page 3343
Page 1
background image

Suspension Strut / Shock Absorber: Technical Service Bulletins
Suspension - Rear Suspension Thumping Noise

R002/98 

THUMPING NOISE FROM REAR SUSPENSION

TOWER

DESCRIPTION

All 1997-98 Protege with VINs lower than JM1 BC14**W0186598.

DESCRIPTION

When driving on a rough road, a thumping noise is heard from the rear left and/or right suspension tower. This is caused by the adjusting sheet allowing
the rear shock absorber and coil spring assembly to make contact with the body panel. A modified adjusting sheet is available to prevent this noise

Customers complaining of this should have their vehicle repaired according to the following procedure.

REPAIR PROCEDURE

1.

Verify customer complaint.

2.

Remove the rear shock absorber and coil spring assembly. Refer to the Workshop Manual section R(02) for removal and installation procedures.

3.

Replace the adjusting sheet on the assembly with the modified part.

Suspension - Rear Suspension Thumping Noise|Page 3348 > < Suspension - Rear Suspension Thumping Noise|Page 3343