Protege LX L4-1489cc 1.5L DOHC MFI (1998)
6.
Remove the transaxle oil pan. Inspect the transaxle fluid temperature sensor wires for shorts against the metal clip which is attached to the control
valve body as shown. If the wires are exposed due to insulation being worn away at the clip, wind the newly established part (tube) around the
damaged location. Then, confirm there is no continuity between each terminal and the transaxle case.
Note
^
After protective tube is installed to wiring, make sure tube is located under metal clip.
^
If there is no continuity, proceed to STEP 8.
^
If there still is continuity, a short circuit exists at another location within the harness. Replace the valve body harness (coupler) with a
modified part. Proceed to STEP 7.
7.
Install a modified solenoid valve body harness (coupler) using the following steps.
A.
Disconnect the valve body harness from the valve body.
B.
Remove valve body.
C.
Remove manual plate and related components as necessary.
Note
^
Study component arrangement before disassembly.
