Protege LX L4-1489cc 1.5L DOHC MFI (1998)
Axle Shaft: Service and Repair
Constant Velocity Type
Drive Shaft Removal and Installation
DRIVE SHAFT REMOVAL/INSTALLATION
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the
harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an
appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Fill the transaxle with the specified amount and type of oil, and inspect for oil leakage.
Drive Shaft Removal Note
CAUTION: The sharp edges of the drive shaft snap ring can slice or puncture the oil seal. Be careful when removing the drive shaft from the
transaxle.
1. Separate the left side drive shaft from the transaxle by prying with a bar inserted between the outer ring and the transaxle, as shown in the image.
