Protege LX L4-1489cc 1.5L DOHC MFI (1998)
Transmission Speed Sensor: Service and Repair
INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the battery, air cleaner component, and battery carrier.
3. Disconnect the input/turbine speed sensor connector.
4. Remove the input/turbine speed sensor.
5. Apply ATF to a new 0-ring and install it on a new input/turbine speed sensor.
6. Install the input/turbine speed sensor.
Tightening torque 7.9 - 10.7 Nm (80 - 110 kgf-cm, 70 - 95 inch lbs.)
7. Connect the input/turbine speed sensor connector.
8. Install the battery carrier, air cleaner component, and battery.
9. Connect the negative battery cable.