Protege LX L4-1489cc 1.5L DOHC MFI (1998)
4. Insert the blade of the SST into the sealant, and pull on the bar to cut the sealant near the glass as shown
5. Remove as much sealant as possible from between the body and the glass.
6. Carefully clean around the edge of the glass and the adhesion surface of the body.
7. Apply primer onto the bonding area of the glass, body, and new windshield molding by using a brush. Use only glass primer on the glass and body
primer on the body and molding. Keep the area free of dirt and grease, and do not touch the surface. Allow the primer to dry for approximately 30
minutes.
8. Apply a 3 mm {0.12 in} bead of sealant between the glass and the body.
9. Reshape the sealant as shown if necessary.