RX7 2RTR-1308cc 1.3L MFI (1991)
3. Connect the heat gauge unit connector and ground.
4. Connect the hoses to oil filler pipe.
Housing Oil Nozzle and Metering Oil Tube
Install the housing oil nozzle and the oil tube and new washers to the front and rear rotor housing.
Tightening torque: 16-23 N.m (1.6-2.3 m-kg, 12-17 ft-lb)
Note: The oil tube ends are colored. For front housing White For rear housing Yellow.
Intake Manifold
1. Install the new intake manifold gasket on the engine.
2. Install the auxiliary port valves so that the bigger side of the pin is aligned to the matching mark.
3. Install the intake manifold.
Tightening torque: 19-25 N.m (1.9-2.6 m-kg, 14-19 ft-lb)
4. Connect the couplers of the split air solenoid valve and port air solenoid valve.
5
Connect the vacuum pipes.
Fuel Injector and Delivery Pipe
1. Insert the air bleed socket and rubber insert to the injector holes.
