RX7 2RTR-1308cc 1.3L MFI (1991)
2.
Lubricate and slide the new shaft seal over the SST. Figure 5.
NOTE:
Ensure the shaft seal is installed in the correct direction. Figure 5.
3.
Place a 21 mm (13/16 in) deep socket over the shaft. Figure 6.
4.
Push the shaft seal down until it bottoms. Remove the seal protector SST. Figure 6.
NOTE:
Use hand pressure ONLY to install the shaft seal.
5.
Install the snap ring, the felt, and the shaft key. Figure 7.
CAUTION:
Ensure the snap ring is installed with the tapered edge down (large diameter side up).